Inventor General

New Member
Posts: 1
Registered: ‎12-26-2012
Message 1 of 2 (121 Views)

Convert splines

121 Views, 1 Replies
12-26-2012 10:00 AM



I have a drawing of a map full of polylines and some splines. I want to somehow select or show only the splines for then to convert them into polylines to make them ready for laser printing.


The drawing has thousands of lines so selecting one by one to see if its a spline will take forever. 


Any ideas? 



*Expert Elite*
Posts: 3,179
Registered: ‎12-07-2011
Message 2 of 2 (115 Views)

Re: Convert splines

12-26-2012 10:30 AM in reply to: ernsthra

Welcome to the forum.

What about setting up layers and placing these polylines on that layer.  Then you can turn on/off

and show only what you need to show.

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor