Inventor General

Reply
Member
Posts: 5
Registered: ‎03-16-2003
Message 1 of 1 (169 Views)

Contour Flange Adaptivity

169 Views, 0 Replies
10-30-2002 09:56 PM
I always get a constraint error when I try to adapt, in the assembly, the extruded length of a sheetmetal part created by the contour flange method. Is this supposed to work or do you think I am doing something wrong?

Scott

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube