Inventor General

Valued Contributor
Posts: 96
Registered: ‎02-08-2011
Message 1 of 3 (176 Views)
Accepted Solution

Content Center Library

176 Views, 2 Replies
12-11-2013 02:34 AM

Hi to all,


if i have created a custom content center library,  where all content center parts use my material "Steel XYZ", is there a way to use it in old assemblies that use a no custom content center library?


I mean, i have 100 assemblies that use bolt with Steel Mild material... can i change that material changing thecontent center library and using mine that use "Steel XYZ"?


Thanks for support!



*Expert Elite*
Posts: 2,832
Registered: ‎04-06-2010
Message 2 of 3 (156 Views)

Re: Content Center Library

12-11-2013 05:40 AM in reply to: pompeo79

You would need to open each of those assemblies and use Replace From Content Center on the parts.  You can do a "Replace All" on each part, but there is (unfortunately) no magic button that will just switch all of your fasteners to the new library.  If the fasteners came from a read only library, you may be stuck replacing them all the old fashioned way. 



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


Valued Contributor
Posts: 96
Registered: ‎02-08-2011
Message 3 of 3 (152 Views)

Re: Content Center Library

12-11-2013 06:22 AM in reply to: cbenner
Thank You Chris!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor