Inventor General

Active Member
Posts: 6
Registered: ‎10-21-2011
Message 1 of 2 (206 Views)
Accepted Solution

Characters in a Datum Target

206 Views, 1 Replies
05-14-2012 01:01 PM

Can more than 4 characters be used in the bottom of a datum target?

Active Member
Posts: 6
Registered: ‎10-21-2011
Message 2 of 2 (187 Views)

Re: Characters in a Datum Target

05-21-2012 04:25 AM in reply to: brian

The Autodesk support team indicated the following.


'The Datum Target symbol only accepts 4 characters as you are already aware of.  The inclusion of more characters has been requested as a wish-list item for future Inventor releases, however the request is still being analyzed by the Development team.

A work-around to include more than 4 characters in the symbol is to create a Sketched Symbol with the appearance of Datum Target and include prompted entries.  If you want to use that Sketched Symbol in different drawings you will have to save the symbol in a template drawing and use that template for all the drawings that require the symbol with more than 4 characters.'


They also included a vidoe and sample.  It is an OK work around.


The benifit of the Datums is the cirle or rectangle that is created with the datum.





You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor