I have an assembly with several analogical parts and they have sketches with project geometry inside this assembly ("Adaptive" function works good, look pic "Works").
Unfotrunately, one part of parts doesnt work perfectly ("Adaptive" function is not active, look pic "Doesnt work"),
why it is soo??
Solved! Go to Solution.
Was this part adaptive in another assembly if so open part go to documents uncheck adaptive in assembly.
Once you used a part as adaptive in an assembly, the part document's "Adaptively Used in Assembly" option is enabled (under the Document Settings \ Modeling tab). Note that the part's adaptivity can be driven only by ONE assembly. So if you have more instances of the part in the assembly only one of them can be adaptive. Also if the part is inserted into more assemblies only one of them can control its adaptivity. If you want to change which assembly should control it, you have to uncheck this flag using the Document Settings dialog and then enable the adaptivity in the new controlling assembly.
Maybe it sounds related to your dataset. So could you attach the dataset for further investigation?
I have unchecked this tick and now it works well!
However, other parts work with this checked tick anyhow..... interesting...
Anyway, in general it works, Thanks!
Some that have it checked and work is because they are in the assembly they was made adaptive too..
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.