Inventor General

Reply
Valued Mentor
graemev
Posts: 277
Registered: ‎11-03-2011
Message 1 of 5 (216 Views)
Accepted Solution

CC parts saved as custom not updating thumbnails

216 Views, 4 Replies
03-26-2013 11:08 AM

When inserting a Content Center part into an assembly as a custom part instead of as a standard one, then opening and modifying the part, the thumbnail for the new file is not updating to show the modifications.  In this particular instance: a pipe blind flange with an off-center hole drilled through the face.  The thumbnail still shows as the original (and fairly pixelated) CC blind flange.

 

Any suggestions on forcing the thumbnail to update?

*Pro
ampster
Posts: 1,114
Registered: ‎07-26-2005
Message 2 of 5 (212 Views)

Re: CC parts saved as custom not updating thumbnails

03-26-2013 11:21 AM in reply to: graemev

what is set in iProperties > Save tab?

*Pro
jletcher
Posts: 1,946
Registered: ‎05-18-2011
Message 3 of 5 (201 Views)

Re: CC parts saved as custom not updating thumbnails

03-26-2013 11:46 AM in reply to: graemev

Go to iproperties go to the save tab

change to Active window hit capture then hit apply then change back to Active Component iso view on save hit apply again and close. Thumbnail should update.

 

Capture.JPG


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
*Pro
ampster
Posts: 1,114
Registered: ‎07-26-2005
Message 4 of 5 (195 Views)

Re: CC parts saved as custom not updating thumbnails

03-26-2013 11:53 AM in reply to: jletcher

pft, why give them the fish!

 

Show em where it's at and let them figure it out!

Valued Mentor
graemev
Posts: 277
Registered: ‎11-03-2011
Message 5 of 5 (182 Views)

Re: CC parts saved as custom not updating thumbnails

03-26-2013 12:51 PM in reply to: jletcher

Actually, "Active Component Iso View on Save" alone works fine for my needs.

 

Thanks!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube