Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Break View at an Angle

3 REPLIES 3
Reply
Message 1 of 4
Ktelang
1413 Views, 3 Replies

Break View at an Angle

Hello Everyone,

 

Any trick to make create a break view along a sloping edge.

So that the view still appears continuous rather that the one

shown in attached pic.

Thanks

 

------------------------------------------------------------------------------
Config :: Intel (R) Xeon (R) CPU E31245 @ 3.30 GHz, 16.0 GB, 64bit win7
Inventor 2013 and Vault Basic 2013
-----------------------------------------------------------------------------
3 REPLIES 3
Message 2 of 4
Curtis_Waguespack
in reply to: Ktelang

Hi Ktelang, 

 

Unfortunately it isn't possible, but it has been requested in the past. You can add your feedback at the Autodesk feedback link:

 

You can request enhancement and new features using the Feed Back link:
http://inventortrenches.blogspot.com/2011/01/feature-request-for-inventor.html

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com


Message 3 of 4
Ktelang
in reply to: Curtis_Waguespack

Thanks Curtis

 

------------------------------------------------------------------------------
Config :: Intel (R) Xeon (R) CPU E31245 @ 3.30 GHz, 16.0 GB, 64bit win7
Inventor 2013 and Vault Basic 2013
-----------------------------------------------------------------------------
Message 4 of 4
mechdsn
in reply to: Ktelang

A possible "work-around" would be to break the views alignment to its parent view and then rotate the view to a horizontal or vertical orientation. Then, you can use the break view command as normal and add the angle of rotation to the view label that was generated automatically. I would typicallly add something like "VIEW ROTATED 60 CCW" (counter clockwise). Most shops can work with that without too much confusion. It would be great if Autodesk would allow broken angled views in the next release though...

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report