Hello to all!
I'm a newbie with Inventor and I've been tasked with creating a medallion like the one shown below:
I need to know the best way to go about making the rosette (the frills around the center of the medallion). Should I fold a long strip of sheet metal repeatedly? Should I make a single frill and use the circular pattern tool to duplicate it?
Any advice helps. Thank you all,
-Mike Churvis
Solved! Go to Solution.
Solved by JDMather. Go to Solution.
@Anonymous wrote:
Should I fold a long strip of sheet metal repeatedly?
No, no, no
Should I make a single frill and use the circular pattern tool to duplicate it?
Yes
@Anonymous wrote:
On a side note, I've always wondered why the community is so opposed to the Fold tool?
Do it! I challenge you.
There is nothing wrong with the Fold command when appropriate, but almost always there is a better, easier way.