Inventor General

*Keller, Kent
Message 11 of 11 (103 Views)


04-24-2003 01:13 PM in reply to: *Newton, Byron
I have replaced the SaveasDWG macro with a SaveAs macro. It contains macros
to save to all the normal export file formats. All except for DWG and DXF
save using the system defaults only. DWG and DXF use a ini file if one is
set up for it .. right Ken?

Be aware, I can't even say for certain that I have tried each output (bmp,
igs, etc) in each file type (ipt, iam, idw, ipn), but what I did test went
without a hitch. Be sure to let me know if anyone does run into any that
don't work or have problems. then click on the iBatchRun
link and finally at the bottom of the page, get the SaveAs Macros.


Kent Keller

Assistant Moderator
Autodesk Discussion Forum Moderator Program

"Byron Newton" wrote in message
> I will download it when Kent puts it on his web site.
> Thanks guys
> --
> Byron Newton

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor