Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Axonometric view

4 REPLIES 4
Reply
Message 1 of 5
KevinPinks7697
14402 Views, 4 Replies

Axonometric view

I need to create an axonometric view of a model with specific angles (see attached). What is the best and quickest way to do this?

Thx

Kev

4 REPLIES 4
Message 2 of 5
BMiller63
in reply to: KevinPinks7697

 

this link

http://www.ul.ie/~rynnet/keanea/moi.htm

 

and these tools maybe?

 

axonomatric.png

 

 

 

if you use the view cube to look at the corner edge, and then roatate left (at some angle) and then down (at some angle).

 

I didn't work out the angles, but if you do, please post back with them.

 

axo2.png

 

axo4.png

 

 

 

Message 3 of 5
JDMather
in reply to: BMiller63


@BMiller63 wrote:

  

if you use the view cube to look at the corner edge, and then roatate left (at some angle) and then down (at some angle).

 

I didn't work out the angles, but if you do, please post back with them.

 

 


I'm homing in on the angles Right 35 then Down 32 should be close.

 

I'll let the OP fine tune the angles but this was 34 Right then 24 Down.

 

I assume there is some logic rather than my brute force trial-and-error.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 4 of 5
Justin_DeSilva
in reply to: JDMather

Just thought I'd add some clarity. For instance, if you'd like to achieve the axonometric view shown below, then follow these steps..

Capture9.jpg

 

1. In Drawing mode select create custom view

Capture17.jpg

 

2. While in drawing mode select the front of your model.

Capture10.jpg

 

3. Rotate 30 degrees towards the right

Capture13.jpg

 

4. Then rotate the model 15 degrees downwards

Capture15.jpg

Message 5 of 5

Seeing that this is possible in a 2D drawing view, can someone tell me how to create a customized isometric/axonometric view in the modeling environment?

 

Currently the only options are front, back, top, bottom, left, right, isometric and random...

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report