Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Authoring in Cable Harness

3 REPLIES 3
SOLVED
Reply
Message 1 of 4
safwan
255 Views, 3 Replies

Authoring in Cable Harness

Hi guys,

 

I wanna ask, are there any ways to authoring connectors in 2 direction? For examples, direction 12 o'clocks and 6 o'clocks. I wanna pin wires to both direction. I don't want to create 2 parts because it is just 1 part which just have wires going out in 2 direction.

 

I also don't want to use segment (inheret segement point).

 

Are there any ways? Thanks a lot guys.

3 REPLIES 3
Message 2 of 4
mcgyvr
in reply to: safwan

yes.. set termination type as insulation displacement.



-------------------------------------------------------------------------------------------
Inventor 2023 - Dell Precision 5570

Did you find this reply helpful ? If so please use the Accept Solution button below.
Maybe buy me a beer through Venmo @mcgyvr1269
Message 3 of 4
safwan
in reply to: safwan

It works. Thank you very much.

Message 4 of 4
safwan
in reply to: mcgyvr

And another thing, I've done the insulation type and it works for wire. But when creating cable, I cannot change the direction of pin 2.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report