Inventor General

Reply
New Member
Posts: 1
Registered: ‎04-02-2013
Message 1 of 2 (420 Views)

Animate adaptive tube (flexible tube) and pipe route with inventor studio

420 Views, 1 Replies
04-02-2013 09:21 PM

My question is whether or not inventor studio can animate a flexible tube route that was created in the tube and pipe route environment.

 

I've got hydraulic hoses going to hydraulic cyclinders. the cylinders are attached to a crankshaft so the cylinders move throughout their cycle, thus the hoses move and the hose path changes. 

 

When I drive the constraint which dictates the cylinder position (crank angle) the hoses and fittings from the adaptive pipe route do not update until I stop driving the constraint.

 

then in Inventor studio, I try to animate this constraint (crank angle) and it will not update or animate the crank angle, even though I could drive it earlier.

 

Any ideas?

 

inventor 2013

spelling is not my game

-Bob

*Expert Elite*
blair
Posts: 3,612
Registered: ‎11-13-2006
Message 2 of 2 (383 Views)

Re: Animate adaptive tube (flexible tube) and pipe route with inventor studio

04-03-2013 01:44 PM in reply to: rmeyer3

No, the adaptive tube run, is really just a "Sweep" of a profile along a 3D path. Just an adaptive part within a sub-assembly that can only update after the move has been made (like hitting the up-date icon).

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 PDSU / Sim Mech 2015 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 335.23
SpacePilot Pro 3.17.7, 6.17., 4.11

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube