You must start over - the part is flawed from beginning to end.
Sketch53 not constrained - not symmetrical.
Sketch Vaheplane not symmetrical not constrained
Sketch front rail kogu not constrained and missing Tangent constraints.
Sketch Aluse teine tasapind not constrained, not symmetrical and missing tangents.
I counted 13 sketches needed (all rails can be on two sketches).
Looks like it would take about 2 hours to recreate from scratch.
Be sure to make use of symmetry and use tangent constraints.
Workplane29 appears to be a duplication of Workplane2.
Workplanes 22 and 30 appear to be duplicates.
Large number of duplicate dimensions (use Equal = constraints and Symmetry constraints).
Sketch1 appears to have been Autodimensioned and the dimensions don't make logical sense for manufacturing.
In your first sketch, Aluskontuur, this line is less than .4° from horizontal and goes out to 9 decimal places or more.
The entire part could be significanly simplified if this line can be horzontal.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.