sweep won`t work

[Zac-C]

What do i change or why does the sweep not work on this sketch

[pkainer]

Good morning,

everthing works fine with Inv2014.

Peter

[WHolzwarth]

Sometimes creating another 3DSketch by Include Geometry does help. See file.

Walter

[johnsonshiue]

Hi! The issue is that there is a degenerated line segment (point) in the middle where the two bends are. Sweep does not seem to like the condition. If you replace the two bends with a half circle, it should work better.

Thanks!

[pkainer]

Hello,

this was also my first suspicion. But bend on bend  works fine without a straight pipe segment between (with Inventor 2014).

Peter

[pkainer]

1.You have to change radius 110 to a smaller value like 100 or so.
2.sweeping with 3D-Sketch
3.after sweeping Change radius back to 110mm