Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I'm attempting to make an inside corner, like on crown molding, but in sheet metal. IE>. 2 pieces at 90 degrees to each other and on a 45 degree bias, that meet in the "corner". If possible it should be made from (1) piece of metal. I've tried sweeping a profile, but it won't allow me to unfold it. Any thoughts or suggestions are always appreciated. Thanks
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")