Inventor General Discussion

Reply
Contributor
none1
Posts: 16
Registered: ‎03-30-2012
Message 21 of 24 (144 Views)

Re: inventor 2011 will not give me an angle dim

11-30-2012 10:53 AM in reply to: nannerdw

I disagree not all posts had the intent of answering the question.  I see some of the insulting posts are now gone from this thread.

 

The correct answer would have been "no you cannot tell inventor angular not linear".

 

I did figure out the problem myself.  IT IS A BUG WITH INVENTOR conflicting with other softwares and MS.