Community
Hello Gentelmen,
Suppose I have this part, see stp file attached, that would be made by laser cutting from a flat sheet of polycarbonate and then mending it over a cymindric surface, 400mm in diamiter. The question is how do I "undend" this 3d part, to get a profile for lase cutting?
Thanks,
R
Solved! Go to Solution.
Solved by JDMather. Go to Solution.
I cannot figure out why you are using the technique you are using.
See attached.
Click on Flat Pattern.
Can't find what you're looking for? Ask the community or share your knowledge.