Inventor General Discussion

Inventor General Discussion

Posts: 11
Registered: ‎11-23-2012
Message 1 of 3 (569 Views)

how to make (*.ide)

569 Views, 2 Replies
11-23-2012 03:58 AM

dear sir, i have face a problem while doing punch tool operation please suggest me how to do?








New Member
Posts: 1
Registered: ‎11-24-2012
Message 2 of 3 (504 Views)

Re: how to make (*.ide)

11-24-2012 08:32 PM in reply to: admin

You need to extract a sketch to make an iFeature.  I am not sure what you did judging by your jpg, but you definitely did not extract a sketch.  The iFeature needs to begin with a center point, and then base your sketch(es) from that.  Then cut or extrude.  After that, look for the "extract iFeature" function

Good luck!

Product Support
Posts: 225
Registered: ‎10-14-2007
Message 3 of 3 (471 Views)

Re: how to make (*.ide)

11-25-2012 08:04 PM in reply to: admin

From the screenshot, it sound there is no right to publish iFeature into the Content Center Library.


So go to Application Options->Center Center.

At here, check the Access Options. You might use Vault Sever.


Secondly, back to the project dialog box, check the Configure Center Center Libraries, check you have access and modify right to the center center libraries.

Yong Jing
Product Support Specialist
Frontline Technical Support, CSS. GCSO
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.