Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
lis_wang
Posts: 433
Registered: ‎11-26-2003
Message 1 of 1 (52 Views)

content center file

52 Views, 0 Replies
11-02-2012 12:07 AM

I placed a lip seal component from content center into an assembly file and I want to change it to a normal file. The reason I do this is because I want to create a break out section in 2D drawing so it can be sectioned without click "section all parts". If I click "section all parts", shaft will be also sectioned and that is not what I want.  

 

Is there solution? I attach my file here.

 

Thanks

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.