Inventor General Discussion

*Adams, Brad
Message 1 of 1 (18 Views)

bend extents lines get turned on after changes in model

18 Views, 0 Replies
11-20-2002 02:00 AM
Does anybody else see this happen? I made a
sheetmetal angle and created a flat. I then created an IDW and place a view
of the flat pattern. I dimension everything out, everything is ok (no bend
extent lines on the flat.) I close out the IDW. I desided to make the sheetmetal
angle longer, so I make the changes in the IPT and save the file. Now I open up
the IDW and the bend extent lines are now onin the flat. I turn the bend extents
off and everything is fine. If I leave the IDW open and make a change to the IPT
the bend extents stay off. However it seems that if I close the IDW and make a
change to the IPT then reopen the IDW the bend extent lines are on again for the

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor