Ah Ha! Thanks Sean, I knew is was something simple (stupid).
kp
"Sean Dotson" wrote in message
news:1FDF8E0B99B6B04FA9BBDEA8EFAA7D55@in.WebX.maYIadrTaRb...
> What is the setting under Tools/App Options/Assy / enable Cross Part... is
> it checked? If not then you'll either need to check it or hold down ctrl
> while projecting geometry.
>
> --
> Sean Dotson, PE
> http://www.sdotson.com
> Check the Inventor FAQ for most common questions
> www.sdotson.com/faq.html
> -----------------------------------------------------------------------
> "Keith Panik" wrote in message
> news:C68D931B3ECF789DA63AE931E12A4750@in.WebX.maYIadrTaRb...
> > I've never had a problem with this in IV5.3. I've upgraded to IV6 now i
> > cannot get projected geometry to be adaptive. Place a part into an
> assembly,
> > start a sketch, project geometry. I get the feature outlines in pink but
> no
> > references under the sketch. If the sketch is not already adaptive it
will
> > not go adaptive automatically like it should. Any suggestions on how to
> get
> > this working again?
> >
> > pentium 4 1.6 GHz, Win2000 sp4, 3D Labs Oxygen GVX1, IV6 SP2
> >
> >
> > Thanks,
> > keith
> >
> >
>
>