Inventor General Discussion

Inventor General Discussion

Reply
Employee
BryanKelley
Posts: 48
Registered: ‎04-18-2005
Message 11 of 12 (94 Views)

Re: Work Plane definition: axis and point

05-23-2012 12:13 PM in reply to: barnadaniel

Hello Daniel,

 

  Please see the attached Word document to see if I understand your request properly.

 

Thanks,
Bryan

Sr. Software QA Engineer
DLS – Mechanical Design
Valued Mentor
Rich.O.3d
Posts: 525
Registered: ‎08-19-2008
Message 12 of 12 (78 Views)

Re: Work Plane definition: axis and point

05-23-2012 07:05 PM in reply to: BryanKelley

Bryan,

 

That would be my interpretation of the op's question.

 

I regularly wish I had this functionality...cant think of specific reasons off the top of my head, but im sure at least once or twice a week.

 

Also another good one would be a plane to bisect the angle between two, existing, non parrallel planes

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.