Inventor General Discussion

Inventor General Discussion

Active Contributor
Posts: 36
Registered: ‎06-01-2012
Message 1 of 3 (198 Views)

What tool to use?

198 Views, 2 Replies
10-26-2012 08:33 AM

Any advise on what tool I should be using when creating this bend?

*Expert Elite*
Posts: 2,473
Registered: ‎09-13-2011
Message 2 of 3 (173 Views)

Re: What tool to use?

10-26-2012 09:45 AM in reply to: jeregonn

I would use lofted flange.

Mike (not Matt) Rattray

*Expert Elite*
Posts: 26,508
Registered: ‎04-20-2006
Message 3 of 3 (164 Views)

Re: What tool to use?

10-26-2012 09:55 AM in reply to: jeregonn

I would use Contoured Flange and then Contoured Roll followed by a couple of other tricks.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.