Try this:
1) Start new part (middlepipe.ipt)
2) Derive Master.ipt
3) Extrude sketch2 as a surface (both outer pipes)
4) Extrude sketch1 to pipe on left (surface), using minimum solution
5) Extrude sketch1 again to pipe on right (surface), using minimum solution
"Laurence Yeandle" wrote
in message news:29D431FA91E33E1D72448CF37E4E3588@in.WebX.maYIadrTaRb...
> This is a bug IMO whatever.
> I am afraid I am so rusty on IV that I have even forgot how I made a
tubular
> model similar to your work albeit on a smaller scale.
> But for now you will have to accept a short cut to what ever my method
was,
> flip normal work plane 1.
>
> Perhaps someone can send this one to Autodesk?
>
> --
> Laurence,
>
> Power is nothing without Control
> ---
>
>
> "frm" wrote in message news:f18c1d2.3@WebX.maYIadrTaRb...
> > Morning Kent
> > I tried editing the tubes and they behave as you said. Weird.
> > Well maybe I just have to do it the other way. But it's annoying when
you
> are working on a 60 to 100 meter jacket with a lot of cross bracing.
There's
> much scrollwork to do in the browser panel 🙂
> > This might be something for the wish list. "Minimum solution both
> directions".
> > Thank's again
> >
> > Regards
> >
> > Flemming
> >
>
>