Inventor General Discussion

Inventor General Discussion

Reply
New Member
chissam
Posts: 2
Registered: ‎12-13-2011
Message 1 of 4 (183 Views)

Tube and Pipe...

183 Views, 3 Replies
12-13-2011 09:40 AM

Please direct me to a tutorial or something similar that will help me set-up the Tube and Pipe functionality in Inventor 2012.  Apparently it was not installed or configured at installation.

*Expert Elite*
DarrenP
Posts: 7,227
Registered: ‎09-13-2007
Message 2 of 4 (178 Views)

Re: Tube and Pipe...

12-13-2011 09:50 AM in reply to: chissam

is this inventor or Inventor Pro?

http://usa.autodesk.com/autodesk-inventor/compare/

it matters

New Member
chissam
Posts: 2
Registered: ‎12-13-2011
Message 3 of 4 (174 Views)

Re: Tube and Pipe...

12-13-2011 09:57 AM in reply to: DarrenP

Autodesk Inventor 2012, I don't guess it's "Pro".

*Expert Elite*
cbenner
Posts: 3,206
Registered: ‎04-06-2010
Message 4 of 4 (159 Views)

Re: Tube and Pipe...

12-13-2011 10:41 AM in reply to: chissam

Does 2012 not have a "Getting Started" tab on the ribbon?  There are a bunch of videos on YouTube for Inventor, I just searched and there are several for Tube & Pipe.  If you do have the Get Statred tab, there will be tutorials on there as well.

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cbennertipstricks.blogspot.com/


   

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.