Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Stress Analysis

3 REPLIES 3
SOLVED
Reply
Message 1 of 4
best_industry
356 Views, 3 Replies

Stress Analysis

Hi!

 

I'm currently doing a project and it involves the use of a flat rectangular plate/beam. Dimension approximately about 100mm by 10mm by 2mm. A constant load will be applied on the end of the surface. I would like to find out if there is a way to find out the maximum number of times i can apply the load (after applying the load, it will be removed and applied on the same point again) to the beam until it fails? I would also like to know if i can apply mulitple loads, at different internal and achieve this too?

 

Thank you!

3 REPLIES 3
Message 2 of 4
JDMather
in reply to: best_industry

You will need some othe product - perhaps Autodesk Simulation.
You cannot do this analysis in Autodesk Inventor.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 3 of 4
best_industry
in reply to: JDMather

Thank you for the response JDMather

 

Which simulation software will allow me to find out fatigue failure? Autodesk Simulation 360 or Autodesk Simulation Multiphysics?

Message 4 of 4
JDMather
in reply to: best_industry

You should probably post your question over here

http://forums.autodesk.com/t5/Autodesk-Simulation-Mechanical/bd-p/396


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report