Community
I know we can cut a flat pattern out of 1/4" steel that can be rolled to make this V-Chamber. We have made several, from old marked up flat patterns. I would like to re-create this in 3d from sketchs that can be dynamic, so when the customer requests changes to the volume, the sketch can be tweaked to get the new flat patterns.
But, I am unsure where to start.
Any Advice?
I don't think any 3D sketches are needed.
Can you attach your initial attempt here.
I would do Revolved Surface.
Trim
Thicken.
Post screen shot of one of your existing flat patterns.
The CADWhisperer YouTube Channel