Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
PaulB108
Posts: 160
Registered: ‎05-05-2009
Message 1 of 2 (102 Views)

Sending assembly to 3rd party - easiest way to do this?

102 Views, 1 Replies
11-25-2013 12:48 PM

 

Hello,

 

I have an assembly I wish to forward to a contractor. It is only small - containing some basic FEA (213 KB). What is the easiest, most effective way to do this? Pack and Go?

 

Obviously I have never done it before...

 

 

Regards Paul.

Inventor Professional 2014.
Windows 7 64 bit.
*Expert Elite*
blair
Posts: 4,027
Registered: ‎11-13-2006
Message 2 of 2 (96 Views)

Re: Sending assembly to 3rd party - easiest way to do this?

11-25-2013 01:17 PM in reply to: PaulB108
If they are on the same version of Inventor, then the Pack-And-Go will work fine. If they don't have Inventor you may want to have a conversation with their CAD person as to what works for them as well. If they aren't on Inventor, good chance that the FEA data will be lost in conversion to different systems as the FEA data is very specific to CAD versions.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 up2 PDSU / Sim Mech 2015 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 335.23
SpacePilot Pro 3.17.7, 6.17., 4.11
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.