Repair tube constraints in tube and pipe ?

[Retselnitram]

How do I repair a tubing constraint?

I use tubing in inventor, I always attached tube to whatever fittings I am using and everything is fine but if something gets moved that the end of the tube loses its contraint I'm ready to jump off a cliff!

Is there any way to get the end of the 3D sketch contrained to the fitting again?

Up until now I have always had to deleted the route and started over.

This is not very productive.

Any help would be greatly appriciated.

Inventor Pro 2014

[cbenner]

Try Manage\Rebuild All.