Inventor General Discussion

Inventor General Discussion

Reply
Active Member
antonioxxl
Posts: 8
Registered: ‎08-29-2011
Message 1 of 2 (174 Views)

Publishing custom structural shape to Content Center

174 Views, 1 Replies
04-04-2012 10:51 PM

How do I publish some custom structural shape to Content Center so I could use it in custom length... It works if I use frame generator, but if I would just like to add It from Content Center, It's only available in "base length"...

Employee
NicolasXu
Posts: 124
Registered: ‎10-24-2008
Message 2 of 2 (161 Views)

Re: Publishing custom structural shape to Content Center

04-05-2012 02:05 AM in reply to: antonioxxl

Hi,

 

It could be done in Content Center Editor, please try the following steps:

 

1. Go to the Content Center Editor.

2. Right click the family and select "Family table".

3. Right Click the Base Length column, and select Column Properties.

4. Check "Expression" checkbox, and select the Custom Column radio button.

5. Specify the range

 

Thanks,

Nicolas



Nicolas Xu
Sr. SQA Eng.
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.