Inventor General Discussion

Inventor General Discussion

Reply
Member
rodrigotito
Posts: 4
Registered: ‎11-21-2011
Message 1 of 2 (59 Views)

Publish Frame Content Center

59 Views, 1 Replies
04-17-2012 07:40 AM

I am trying to publish a profile in my library and I can not.
The difference I noticed is that now I'm working on sheet metal environment and sometimes it was in part.

In the process get an error stating that there is a point in the design of extrusion ... Only if I can publish my piece is an extrusion?

Attached is the part that I can not publish

 

Thanks!

 

Inventor 2012

*Expert Elite*
Curtis_Waguespack
Posts: 2,874
Registered: ‎03-08-2006
Message 2 of 2 (56 Views)

Re: Publish Frame Content Center

04-17-2012 07:52 AM in reply to: rodrigotito

Hi rodrigotito, 

 

Rob Cohee has a video on the subject of publishing sheet metal components to use in Frame Generator:

 

http://youtu.be/1Ff9yIVNAa4

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.