Inventor General Discussion

Inventor General Discussion

Reply
Active Member
DanielBakker
Posts: 10
Registered: ‎08-12-2012
Message 11 of 12 (112 Views)

Re: Problem creating a loft

08-12-2012 02:31 PM in reply to: safiredesignengineers

of course, works like a charm :smileywink:

I saw you turned the option 'new solid' on, but what was it that you changed in the sketch?

Mentor
safiredesignengineers
Posts: 581
Registered: ‎06-28-2008
Message 12 of 12 (98 Views)

Re: Problem creating a loft

08-13-2012 03:05 AM in reply to: DanielBakker

Im not sure if it was causing the issue but I stripped back the sketches so they were simpler:

- I deleted your circle sketch Guide rail as this may not of projected properly and was not constrained, I used the edge of the bell for the rail

- on both your 2d sketches for the loft I saw there was some reference lines projected through so i deleted them as well as not required and i think they were being used in the loft.

 

A

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.