Inventor General Discussion

Inventor General Discussion

Reply
New Member
mgudopp
Posts: 1
Registered: ‎10-17-2012
Message 1 of 2 (165 Views)
Accepted Solution

Peventing Assemby Rotation

165 Views, 1 Replies
10-17-2012 04:17 PM

I want to make an assemby consisting of 3 parts. A crank shaft and a crank pin that screw into threaded holes in a crank disk. How can I insert them and prevent them rotating in their holes but still allow the whole assembly to rotate around the axis of the shaft? Also how could I lock a flywheel on to the shaft so that whole assembly can rotate togeather?

*Expert Elite*
JDMather
Posts: 26,518
Registered: ‎04-20-2006
Message 2 of 2 (158 Views)

Re: Peventing Assemby Rotation

10-17-2012 07:02 PM in reply to: mgudopp

Apply assembly constraints.

Mate workplanes is often a solution.

Use logical sub-assemblies.

 

Attach your assembly here.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.