Inventor General Discussion

Posts: 4
Registered: ‎02-28-2012
Message 1 of 2 (310 Views)

Need Help With Car Model

310 Views, 1 Replies
01-02-2013 06:58 PM

I'm a high school student with a bit too much time on their hands right before Build season starts for robotics. I decided to make a model car but ran into a problem. I know a great way to surface model is to do surface extrudes and to sculpt them all together into one solid body, as depicted here, . While that is relatively simple, I have run into a problem. I am not using the same method as shown in the video, and only have three sketches (front, top, and side). I was wondering if there is any way for me to extrude them all and then cutout whatever doesn't intersect with the other two extrusions? 



Edited by

*Expert Elite*
Posts: 26,294
Registered: ‎04-20-2006
Message 2 of 2 (281 Views)

Re: Need Help With Car Model

01-03-2013 05:10 AM in reply to: pineapplexpressdf

See attached.


There are a bunch of surfacing tutorials in my signature.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor