Inventor General Discussion

Distinguished Contributor
Posts: 163
Registered: ‎10-10-2007
Message 1 of 1 (77 Views)

Lost adaptivity during modification of a tube and pipe run

77 Views, 0 Replies
02-01-2013 02:08 PM

What would cause a tube run to lose adaptivity. Was trying to add a part to define an area to constrain the tube route to, and after editing the tube run was no longer adaptive 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor