Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Inventor studio

9 REPLIES 9
SOLVED
Reply
Message 1 of 10
lis_wang
519 Views, 9 Replies

Inventor studio

I create a engine assembly and used "Drive Constrain" to rotate the crank shaft. The animation shows the crank shaft turns continuously in one direction. However, when I animate the constrain in Inventor Studio, the crank shaft turned in two different directions (see the vide file attached).

 

May I know why the crank shaft turns different direction?

 

Thanks  

9 REPLIES 9
Message 2 of 10
JDMather
in reply to: lis_wang

Which of the 3 Angle Constraint types did you use?
Can you use Dynamic Simulation and Publish to Studio instead?


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 3 of 10
lis_wang
in reply to: JDMather

Not matter I used Directed Angle or Undirected Angle, it is still the same. I created a animation by using "Drive Constrain"  and the crank shaft shows only one direction. Please see the file attahced.

Message 4 of 10
lis_wang
in reply to: lis_wang

Any reply?

Message 5 of 10
JDMather
in reply to: lis_wang

Attach your assembly here.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 6 of 10
lis_wang
in reply to: JDMather

As the file is too big, so I zipped into 3 files. This is the 1st zip file.

Message 7 of 10
lis_wang
in reply to: lis_wang

This is the 2nd one

Message 8 of 10
lis_wang
in reply to: lis_wang

This is the last one. Please unzip the 3 zipped files into one folder.

Message 9 of 10
JDMather
in reply to: lis_wang

Make sure the planes used for the angle constraint share the same axis.

I used the assembly origin YZ and the DLM-006 YZ planes for the angle constraint and it worked fine in Studio.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 10 of 10
lis_wang
in reply to: JDMather

Thanks. It solves my preoblem.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report