Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
leech10
Posts: 40
Registered: ‎01-24-2012
Message 1 of 3 (191 Views)

Inventor assembling

191 Views, 2 Replies
09-11-2012 10:59 PM

Hi

 

I need help with assembling parts which I highlighted in the picture. I tried varoius types of constrain but I cannot attach those parts, to have them bound together. Could you please advise me about technique I should use in this particular case. The rest of the clutch part I have done with the success

 

regards

Peter

*Expert Elite*
Cadmanto
Posts: 3,231
Registered: ‎12-07-2011
Message 2 of 3 (142 Views)

Re: Inventor assembling

09-12-2012 10:00 AM in reply to: leech10

Hi Peter,

I would try this command in the assemble tab, to see if it helps you.  Looks like you have some tangent constraints and

I find this command most useful in these situations.

assy.JPG

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

*Expert Elite*
JDMather
Posts: 26,522
Registered: ‎04-20-2006
Message 3 of 3 (126 Views)

Re: Inventor assembling

09-12-2012 11:57 AM in reply to: leech10

Mate - Flush workplanes.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.