Hi All, First post here.I have grapichs issue with with inventor 2014. installed inv 2014 last week. Got lots of crashes, zoom jumbing & chopping with "big" assemblyes ( about 500-1500 parts). These assemblyes runs very good on inv 2013 but not in inv 2014 on this computer. So my plan of action after these issues was reinstalled win7, chip-set..... install certified drivers from autodesk (Nvidia Quadro 4000), new driver for the 3dconnextion for my 3dmouse. After the fresh install with inv2014, i dont have any crash anymore but still have the same symptomes with the grapichs. In inv 2013 i use performance (app. options) but can only use compatiblilty setting in inv2014 if i whant a smooth ride. This is the first time i experienced any issue wtih new Inventor update since Inventor 5,3. Any input to solve my grapichs issue is very welcome
Some computer specs:
win 64bit sp1
Nvidia quadro 4000
Processor: intel(r) Xeon(R) Cpu W3565 " 3,2Hhz 3,19Ghz
Ram: 18 gb
Inv2014 pro with sp1
welcome to the forums
what graphics driver are you using? You mentioned certified ones - these are usually quite old, so it's usually better to use the latest available from Nvidia, try them (with a clean install).
Also, did you install Inventor as recommended - as an admin, UAC and anti virus off, etc.
Thx & thx for the reply,
Before i took the clean install, i tried the latest nvidia driver with no luck. Will try the latest nvidia driver now and see if that helps. I have admin. rights on this computer. But I dont think the virus program and UAC was turn off during installation. I got one person from the Inventor-dealers to check my install-log but he found no errors.
Driver version: 307.45
Can it be that nvidia q4000 is not that compatibel right now with iv2014, or is just me that been unlucky
or is just me that been unlucky
Just you being unlucky..
What issues are you seeing? There are a lot of known graphics issues with the 2014 release, just search the forum.
Chopping and zoom jumbing (sometimes ghosting). Mostly when using the 3d-mouse. I think for a new person with inventor he or she will just accept this grapichs issue/ lag and think this is normal behavior. It's not too bad, but the previous version was completely fluent graphics. maybe I'm hypersensitive or need a good old reboot
"maybe I'm hypersensitive or need a good old reboot"
I wish that would help, but in this case it won't. There is a thread where an Autodesk employee stats some of this will persist until 2015 comes out. It will require a kernel change and therefore not be backward compatible.
Hi RayFeiler, thx for that info.
so my question is now, should I accept this thread as solved or not? Since there is nothing can be done until inventor 2015 get release....
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register