Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎10-24-2012
Message 1 of 3 (3,025 Views)

Inventor 2013- Tube and Pipe Design

3025 Views, 2 Replies
10-24-2012 03:51 PM

I am a drafting instructor who has inventor 2013. Want resources (tutorial, instructional video...) explaining how to use "tube and Pipe design" with inventor 2013.

Posts: 124
Registered: ‎10-24-2008
Message 2 of 3 (2,995 Views)

Re: Inventor 2013- Tube and Pipe Design

10-25-2012 10:12 PM in reply to: gproden



I'd suggest you take a look the official tutorials first if not yet.



Nicolas Xu
Sr. SQA Eng.
Fusion 360 Quality Assurance Team
Autodesk, Inc.
*Expert Elite*
Posts: 3,209
Registered: ‎04-06-2010
Message 3 of 3 (2,981 Views)

Re: Inventor 2013- Tube and Pipe Design

10-26-2012 05:23 AM in reply to: gproden

Agree, that's the best place to start, after that I might check You Tube, lots of AD training videos out there.



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.