Inventor General Discussion

Reply
Active Contributor
flickingerd
Posts: 28
Registered: ‎07-31-2006
Message 1 of 3 (508 Views)

Inventor 2012 Content Center Add-In not loading

508 Views, 2 Replies
09-28-2012 11:05 AM

Hello.  My Content Center Add-In is not loading in Inventor Pro 2012.  It's listed as unloaded in the Add-In manager (see below), and, of course, "Place from Content Center" isn't shown as an option on any of the menus.  If I double-click on Centent Center in the Add-In Manager, the word "Unloaded" changes to "Loaded" and I don't get any errors.  It looks like it should have loaded fine.  But then if I close the Add-In Manager and open it again, it has gone back to "Unloaded".  I haven't found anything that can restore the Content Center functionality.

 

I have installed Inventor Pro 2013, and this could have been around when the Inventor 2012 Content Center broke.  I'm not positive about the timing...  If I start Inv 2013, the Content Center works fine in it.

 

Any suggestions for what to do before uninstalling 2013 and/or reinstalling 2012?

 

Dan

 

Distinguished Mentor
john.retzlaff
Posts: 900
Registered: ‎11-03-2003
Message 2 of 3 (502 Views)

Re: Inventor 2012 Content Center Add-In not loading

09-28-2012 11:10 AM in reply to: flickingerd

You might try doing a repair install on Inventor 2012 to see if that fixes the problem.

John Retzlaff
Active Contributor
flickingerd
Posts: 28
Registered: ‎07-31-2006
Message 3 of 3 (489 Views)

Re: Inventor 2012 Content Center Add-In not loading

09-28-2012 01:16 PM in reply to: john.retzlaff

Thanks.  The problem seems to be solved now.  I did a repair install, which didn't seem to do anything or fix the content center right away.  After a reboot though, the content center seems to be working (reboots didn't help before).  I did some other stuff too, though, so I'm not sure whether the repair install or the other stuff is what did the trick.  (Other stuff = fixing this anti-virus program that had gone haywire and started quarantining legitimate files.  It didn't seem like any of the quarantined files would have an impact on this, but it's hard to say...).

 

Dan

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube