Inventor General Discussion

Reply
Distinguished Contributor
gcross
Posts: 176
Registered: ‎01-11-2001
Message 1 of 2 (180 Views)

Interference not being reported by Inventor 2012-Bug?

180 Views, 1 Replies
08-24-2011 05:05 PM

The attached image shows a small interference between an two assemblies. I tried different selection methods for  the interference check but under no circumstances would it report an iterference occurred even though it's clear one partr is poking through the sheet metal.

 

Is this a bug?

 

The file set is large. I would be glad to send the file set directly to Autodesk FTP but I'm going on vacation & can't send till I get back 2nd week of Sept. If interested I'll try to send tomorrow before I leave.

 

Gary

Inventor Suite 2013 Ultimate
Product Support
Daniela_Koloszko
Posts: 246
Registered: ‎06-23-2010
Message 2 of 2 (157 Views)

Re: Interference not being reported by Inventor 2012-Bug?

08-25-2011 12:00 AM in reply to: gcross

It will be better to submit a case to Product Support via your subscription account and an FTP site could be opened for you to upload the dataset. Then the PS specialists will be able to look at the problem. 



Daniela Koloszko

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube