Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
KevinPinks7697
Posts: 1,012
Registered: ‎09-10-2002
Message 1 of 2 (399 Views)

Importing file into Vectorworks

399 Views, 1 Replies
12-10-2010 04:54 AM

I received a step file from a supplier of enclosures. I then converted the step file to an Inventor solid. One of our sub-contractors uses Vectorworks to render my assembly files. I sent him the file in SAT format but he cannot see anything! I tried converting the solid to iges format, but he canot read iges files in Vectorworks. I had sent him files that I created in Inventor as SAT and there was no problem, but this one particular part (which was created in another software) will not go thru properly. Any suggestions would be greatly appreciated. I have posted the file on the Customer Files under "File Transfer Problem"

Thx

Kev

Employee
AustinLiu
Posts: 164
Registered: ‎12-19-2007
Message 2 of 2 (368 Views)

Re: Importing file into Vectorworks

12-12-2010 06:36 PM in reply to: KevinPinks7697

Didn't find your file...can you show me the link?

btw, make sure you attached Inventor file there.



Austin-Zongjie Liu
Zongjie.Liu@autodesk.com
Software Quality Assurance Manager
Design, Lifecycle & Simulation
Autodesk, Inc.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.