Can you open the assembly at the moment?
If yes does it require updating then it crashes?
Open the part files and rebuild them.
Then reopen the assembly and update?
If it still crashes open an OldVersion of the assy and update that?
--
Laurence,
Power is nothing without Control
---
"Jake Hamilton" wrote in message
news:C7CC95C39127333E0B161DFE550C0EF0@in.WebX.maYIadrTaRb...
> I have a press assy. Everything was constrained properly. I needed to
> shorten the press length wise. With the assy open, I made the necessary
> changes to the parts in their own files. (I'm human so I might have missed
> something.) After all of the changes were made, to the best of my
knowledge,
> I am unable to update the assy, either locally or globally. Usually if
there
> are conflicting constraints, like there would be if I missed something, IV
> tells you that you have to fix or delete the bad constraints. IV is not
> doing this. It just crashes:(
>
> Is there anything that I might be able to do to fix this problem, short of
> rebuilding the assy? Anything like MDT's Audit or Recover commands?
>
> Thank you in advance!!
>
> --
> Jake Hamilton
> Doulos Enterprises, Inc.
> 616-464-3334 Ext. 2#
>
>