Community
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"aldayna" <After
href="mailto:aldayna@navair.navy.mil">aldayna@navair.navy.mil> wrote in
message
href="news:f11f105.-1@WebX.maYIadrTaRb">news:f11f105.-1@WebX.maYIadrTaRb...
updating a part, I noticed that one of the drawing views didn't update fully.
The dimensions "think" that the
view was updated, since the hole center
marks and dimension leaders are all positioned where the geometry
SHOULD
be. But the actual geometry didn't update. This only occurred in the base view
- all of the projected
views updated properly. I've tried forcing an
update by checking and unchecking the defer updates option, but
no luck.
If I create a new base view (of the same view), the geometry is properly
updated. Any ideas? I would
ordinarily just say a few choice words, delete
the view, and "simply" create a new one; but this is the base view
(of
course), and my whole sheet is based on it...
V/R - Nate Alday (IV 6, Dual Xeon 2.2, 2 Gb RAM, Quadro 750XGL, XP
Pro)
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"aldayna" <After
href="mailto:aldayna@navair.navy.mil">aldayna@navair.navy.mil> wrote in
message
href="news:f11f105.-1@WebX.maYIadrTaRb">news:f11f105.-1@WebX.maYIadrTaRb...
updating a part, I noticed that one of the drawing views didn't update fully.
The dimensions "think" that the
view was updated, since the hole center
marks and dimension leaders are all positioned where the geometry
SHOULD
be. But the actual geometry didn't update. This only occurred in the base view
- all of the projected
views updated properly. I've tried forcing an
update by checking and unchecking the defer updates option, but
no luck.
If I create a new base view (of the same view), the geometry is properly
updated. Any ideas? I would
ordinarily just say a few choice words, delete
the view, and "simply" create a new one; but this is the base view
(of
course), and my whole sheet is based on it...
V/R - Nate Alday (IV 6, Dual Xeon 2.2, 2 Gb RAM, Quadro 750XGL, XP
Pro)