Inventor General Discussion

Distinguished Contributor
Posts: 265
Registered: ‎11-28-2011
Message 1 of 2 (147 Views)
Accepted Solution

How to show thread lines in a slice operation

147 Views, 1 Replies
09-09-2013 12:18 AM

After a slice operation i have to make a sketch and complete lines.

For example, if i slice in the middle of a threaded hole, in the slice i don't see the thread lines, i just see as if there was a hole.

Posts: 55
Registered: ‎12-13-2006
Message 2 of 2 (135 Views)

Re: How to show thread lines in a slice operation

09-09-2013 02:04 AM in reply to: Karol-Or



Showing thread edges in slice views is not supported. As a workaround you can use a Section view with a very small section depth (e.g. 0.001).


Hope this helps,


Oto Kaleja


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor