Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
soggys3
Posts: 30
Registered: ‎03-25-2010
Message 1 of 2 (91 Views)

Hidden .ipt

91 Views, 1 Replies
01-07-2014 11:42 AM

All,

 

I have an .ipt that shows up in the vault browser tab in the assembly and drawing environments that is not in my assembly. I have tried everything I can think of to locate this part within the assembly with no luck. I even deleted all parts, preparations, machining ops, welds and planes so all my browser shows are the factory planes, when I go to check it in the .iam/.idw the part (vertical trim) still appears in the browser. My concern is that this part may affect my assemblies mass properties. I have attached screenshots from my .iam and .idw for review. Any help would be greatly appreciated!!!

 

Thanks!!


Shawn

*Expert Elite*
scottmoyse
Posts: 1,634
Registered: ‎06-10-2009
Message 2 of 2 (59 Views)

Re: Hidden .ipt

01-07-2014 02:13 PM in reply to: soggys3

have you checked in your assembly parameters? It could have been linked to in there, for the purpose of extracting a parameter to be used in an assembly extrude/cut?

Cheers
Scott Moyse

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Cheers!


   

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.