Inventor General Discussion

Active Member
Posts: 10
Registered: ‎06-28-2012
Message 1 of 2 (201 Views)

Help with doing a Radial Section Cut

201 Views, 1 Replies
06-28-2012 12:49 PM

Does anyone know if you are able to do a radial section cut? I am trying to take a section of a top view looking down on a coil and there is a bolt row I want to take a section cut down. I can't find any answers on the web for this.

*Expert Elite*
Posts: 3,954
Registered: ‎11-13-2006
Message 2 of 2 (173 Views)

Re: Help with doing a Radial Section Cut

06-28-2012 09:25 PM in reply to: swamiesstrikers

You can do a multi-segment Cut-Line, but your end lines must be parallel to each other to define your view direction. Like your J-J view. Your G-G view won't work because of the directions are at 90d to each other

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 up1 PDSU / Sim Mech 2015 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 335.23
SpacePilot Pro 3.17.7, 6.17., 4.11

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor