Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
to autodesk
this workaround has opened up some other posibilities. previously I tried to loft a boat hull. the solid lofts ok but the shelling fails. I just successfully managed to loft a boat hull by offsetting my frames the amount of the hull skin inwards. I trimmed the deck line off and made a closed loop showing the boat hull cross section minus deck. this single closed C-shaped loop lofts ok.
putting the rails in as 3d curves is still a pain though.(2 surface intersects)..hint..where is that 3d spline...
regards
frans x liebenberg
The rail(s) must intersect the profile, that is, they must
touch. In this example it does not.
According to Help file, it says Under Rails, "A 2D or 3D curve
through a point on each profile shape used to improve shape control. Profiles
must intersect rails".
Ultimately this is a wish as Central Rails are yet to be
implemented in Inventor.
-- Best Regards Richard
Rankin Autodesk Manufacturing Solutions
(Support)
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")