Inventor General Discussion

New Member
Posts: 1
Registered: ‎12-28-2012
Message 1 of 2 (170 Views)


170 Views, 1 Replies
12-28-2012 03:28 AM

Greetings All.


The part i make is from solid model>The part needs to be in sheet metal.What steps do i use to make as sheet metal part and have option to flatten part.I am learning with Education version


Thanks to any one who can help



*Expert Elite*
Posts: 3,207
Registered: ‎04-06-2010
Message 2 of 2 (162 Views)


12-28-2012 04:04 AM in reply to: R-P-T-0

Hi,  I'm afraid I can't help you with the sheet metal.  But I might make afriendly suggestion that you put sheet metal into your Subject line in some way, so that readers looking through the forums will know right away that this is a sheet metal question.  You are more likely to attract the attention of someone who can help you out.


Good luck!



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.