Inventor General Discussion

Inventor General Discussion

Active Member
Posts: 9
Registered: ‎08-24-2011
Message 11 of 13 (302 Views)

Re: From ipt to dxf?

08-25-2011 06:37 AM in reply to: rdyson

Sorry I do remember a selection during install, saw it now, installed all the missing stuff but still not present afterwards


Posts: 99
Registered: ‎09-24-2008
Message 12 of 13 (303 Views)

Re: From ipt to dxf?

08-25-2011 06:38 AM in reply to: rdyson

Looking at your screen capture, you are using 2012. AEC Exchange was renamed to BIM Exchange in 2012 and it is listed in your add-ins and the Environments tab. 

Patrick Miller
Senior Content Developer
Autodesk, Inc.

Posts: 17
Registered: ‎08-26-2011
Message 13 of 13 (172 Views)

Re: From ipt to dxf?

06-22-2012 02:01 PM in reply to: guido66

Reading your post just saved me a boatload of time, thanks for the good advice.



Joe F.
Project Engineer
Traffic and Parking Control Company
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.